Then I'll grab the Midtones control and drag that up to lighten the face to about 70 IRE. Then you can scrub the play head around in that region so the pixels representing the face are clearly moving and visible in the Waveform monitor. Since the face is mixed in with the other detail, it helps to find a region in the timeline where the candidate is moving his head a lot. Now we can concentrate on the face, which is still a little bit too dark.
So, we're probably okay boosting it up even a little more. We can still see the detail in the whites in the circled area in Figure 10 (below). Fortunately, there is no detail on the whiteboard, so we don't have to worry about that. Typically you never want to exceed 100 IRE because that crushes the detail in that region, causing a loss of detail. We can see in Figure 9 (above) that this adjustment has made the face too dark and darkened the whites, which I'll fix by dragging the Highlights button up until the whiteboard pixels are at or close to 100 IRE. I'll keep adjusting the control until the black regions are close to zero IRE. Immediately, the contrast improves because there's a greater range between the whites and the blacks in the scene ( Figure 9, below). I can adjust these regions by selecting the Shadows control and dragging that down. Here, we know the darkest regions in the image should be right around 0 IRE. When you move the Shadows, Midtones, or Highlights buttons, the adjustments are focused within that range of pixels, though, as you can see in the tutorial, the pixels in other ranges are also impacted to a lesser degree. The three remaining color-coded buttons provide control over the Shadows (or blacks), the Highlights (or whites), and the Midtones, which are areas between the darkest and the brightest pixels. The Global control, the largest button on the extreme left, adjusts brightness throughout the entire image. Final Cut Pro X's Color Board controls all provide either 3 or 4 adjustments. We'll work on the video using the Exposure controls ( Figure 8, below). Next is Saturation, which again, we don't need to adjust, while the third is Exposure. This image is fine color-wise, so we're not going to touch that. There are three tab-like regions in the Color Board ( Figure 7, below). To begin, I'll disable auto Balance by clicking the blue box, and then click the right-facing arrow to the right of Correction 1 (see Figure 6, above) to enter the Color Board. In this case, the waveform shows that this adjustment pushed the black pixels down to 15-20, which is an improvement, but the whites still aren't close to 100 IRE, and the brightness of the face was pushed down along with the blacks. Click the blue box to the left of Balance under the Color controls. The first option to try is Balance, triggering an auto-adjustment that lets Final Cut Pro do the work. To turn the Inspector on or off, click the clip in the timeline, click the Inspector (i) icon at the top-right of the timeline, and the controls appear. Figure 6 (below) shows the color controls. Let's look at the toolset Final Cut Pro X provides to accomplish that.